Smart-technologies 3000i Manual do Utilizador descarregar pdf (Página 24)

3000i Installation Guide

To change the image size

To enlarge or shrink the image, loosen the three front-to-back adjustment screws and then

slide the projector backward or forward inside the slots. Once your image is a good size,

tighten the three front-to-back adjustment screws.

NOTE

: Remember to tighten the three front-to-back adjustment screws when you're

finished.

To move the image up or down

Open the front doors, and locate the two thumbscrews at the side of the small mirror

assembly (see figure below).

Loosen the upper thumbscrews on both sides of the small mirror.

Move Image Up or Down

Image-Size Adjustment

Loosen and then slide the

projector backward and

forward inside the three slots

Speaker Panel

(Transparent for Clarity)

Thumbscrew (x 2)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 61 62

Sem comentários

Smart-technologies 3000i Manual do Utilizador Página 24